1/10 Scale LED Police Light Bar

This LED light bar is the perfect addition to your law enforcement or emergency scale vehicle. The dimensions are sized to fit perfectly on a 1/10 scale body. It features 16 total LED mounted on a chip board controlled by 2 momentary switches. One switch controls the 4 red and 4 blue LED on the front panel, while the other switch controls the 8 amber LED on the rear. The switches also provide the choice of 9 different flash modes allowing different strobing patterns and effects. This bar will be the perfect finish on any RC or scale model.

Specifications:

Length: 114mm
Width: 24mm
Height: 6.15mm
Wire Harness with Power Switch
2 Momentary switches
9 Flash modes
16 Total LED
4x Red
4x Blue
8x Amber
3v V 12volt D.C. Input

Package Includes:

16 LED light bar
Plastic Silver Housing
2 Momentary Switches
9volt battery clip
Mounting bolts, washers, and nuts
Heatshrink

*Clip connectors are pre-soldered
*The light will run on 3-12volts. Hook up a battery or power them directly from your receiver.
*LED brightness will depend on the voltage supplied.